Swim Spas represent distinct challenges when it pertains to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same reasons a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot more difficult.
Getting a brand-new swim spa is an interesting occasion in life. You’re anticipating the workout you’ll get from using it. Possibly you’re a little relieved to have actually finally made a selection from the various models you took a look at. At any rate, you most likely weren’t believing much about the cover you would use.
Typically, the cover that gets back with your brand-new purchase will be a 4 area stiff foam filled cover that will split in the center and go off both ends.
No big deal.
Till it begins to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design flaw. Built in obsolescence because as quickly as it is put in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper won’t make any difference. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are really little as they increase from the water surface area. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.
It occurs slowly and on a Swim Spa Cover which is made from individual sections, at varying speeds. So eventually you’ll notice a couple of of the sections are really getting heavy. The bar lifters on the ends of the swim spa aren’t much help due to the fact that you still need to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a different style for their Swim Spa Covers
Instead of using a number of foam panels to develop Swim Spa Covers that will eventually wind up in some land fill, they created one that utilizes air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate much better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or fall apart at the seams either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not prepared to purchase today, bookmark this site so you can find it once again when you’re ready!