Swim Spas represent unique difficulties when it comes to covering them.
We can all concur that the swim spa has to be covered when not in use for all the same reasons a hot tub requires a cover. The obstacle is that because of the length of the swim spa and the height of the sides, getting rid of and changing the cover can be a lot more difficult.
Getting a new swim spa is an interesting occasion in life. You’re looking forward to the workout you’ll get from using it. Perhaps you’re a little relieved to have actually finally selected from the different models you took a look at. At any rate, you probably weren’t thinking much about the cover you would use.
Usually, the cover that gets home with your new purchase will be a four section stiff foam filled cover that will split in the center and go off both ends.
No big deal.
Until it begins to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design defect. Integrated in obsolescence because as quickly as it is put in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any difference. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are extremely little as they increase from the water surface. They make their method into the little cracks and crevices in the foam.

Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It takes place gradually and on a Swim Spa Cover which is made of private sections, at differing speeds. So eventually you’ll notice a couple of of the sections are actually getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance due to the fact that you still have to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com came up with a different design for their Swim Spa Covers
Instead of using a number of foam panels to build Swim Spa Covers that will eventually wind up in some land fill, they created one that utilizes air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or break down at the joints either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the cover for it.
If you’re not prepared to purchase today, bookmark this site so you can discover it once again when you’re all set!