Swim Spas represent distinct challenges when it concerns covering them.
We can all agree that the swim spa has to be covered when not in use for all the same factors a hot tub needs a cover. The difficulty is that because of the length of the swim spa and the height of the sides, eliminating and changing the Swim Spa Cover can be a lot more difficult.
Getting a brand-new swim spa is an amazing occasion in life. You’re eagerly anticipating the exercise you’ll get from using it. Perhaps you’re a little relieved to have actually lastly made a selection from the different models you looked at. At any rate, you probably weren’t believing much about the Swim Spa Cover you would use.
Usually, the cover that gets home with your brand-new purchase will be a four section rigid foam filled Swim Spa Cover that will divide in the center and go off both ends.
No big deal.
Till it begins to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design flaw. Built in obsolescence since as quickly as it is put in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any difference. In fact you could have it under a roof and the Swim Spa Cover will still get heavy.
The factor is the steam from the water. The particles of steam are extremely small as they increase from the water surface. They make their method into the little fractures and crevices in the foam.

Then as the steam cools it forms back into a liquid and ends up being caught in the Swim Spa Cover
It happens slowly and on a Swim Spa Cover which is made of specific areas, at differing speeds. So ultimately you’ll observe a couple of of the areas are truly getting heavy. The bar lifters on the ends of the swim spa aren’t much aid since you still have to raise that heavy Swim Spa Cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com came up with a different style for their Lightweight Swim Spa Covers
Instead of using numerous foam panels that will ultimately wind up in some garbage dump, they created Lightweight Swim Spa Covers that uses air chambers that do not suck up moisture.
In fact SpaCap.com Lightweight Swim Spa Covers are easy to use, insulate better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these Lightweight Swim Spa Covers won’t fade, or break down at the joints either. So if you own a swim spa, and you intend to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to order today, bookmark this site so you can discover it again when you’re prepared!